Configuring Fujitsu ETERNUS systems
Fujitsu ETERNUS systems can be configured for attachment to the IBM Spectrum Virtualize™ system.
- Supported models of the Fujitsu ETERNUS
The IBM Spectrum Virtualize system supports specific models of the Fujitsu ETERNUS series of systems. - Supported firmware levels for the Fujitsu ETERNUS
The Fujitsu ETERNUS must use a firmware level that is supported by the IBM Spectrum Virtualize system. - User interfaces on the Fujitsu ETERNUS
Ensure that you are familiar with the user interface application that is used by the Fujitsu ETERNUS. - Configuring the Fujitsu ETERNUS
To enable attachment to the system, you must configure the Fujitsu ETERNUS. It is important that you use the correct settings to avoid data access problems. - Zoning configuration for the Fujitsu ETERNUS
If LUN mapping mode is used for a Fujitsu ETERNUS port, you must exclusively zone the IBM Spectrum Virtualize system with this target port. - Migrating logical units from the Fujitsu ETERNUS to the IBM Spectrum Virtualize system
You can use the standard migration procedure with the following restrictions: - Concurrent maintenance on the Fujitsu ETERNUS
Concurrent maintenance is the capability to complete I/O operations to a Fujitsu ETERNUS while simultaneously completing maintenance operations on it. - Advanced functions for the Fujitsu ETERNUS
The Fujitsu ETERNUS system provides several advanced copy functions. Do not use these advanced copy functions for storage that is managed by the IBM Spectrum Virtualize system, even if the volume cache is disabled or set to read only.