chnodebootdrive

Use the chnodebootdrive command to change a drive or synchronize the drives on a system if a drive or field-replaceable unit (FRU) replacement drive breaks.

Syntax


>>-chnodebootdrive--+-----------------+--+- node_id---+--------><
                    '- -sync-- -force-'  '- node_name-'

Parameters

-sync: (Optional) Specifies synchronization of drives marked can_sync.
-force: (Optional) Forces synchronization (though taking the node offline might cause a volume to go offline).
Important: Using the force parameter might result in a loss of access. Use it only under the direction of your product support information.
node_id | node_name: (Optional) Specifies the ID or name of the node.

Description

The command identifies and synchronizes drive information for system drives.

Specifying -sync causes a node restart on the specified node. This restart is not successful if any volume depends on that node.

Important: If -force is also specified, the system does not check for dependent volumes.

An invocation example

chnodebootdrive

The following output is displayed:

No feedback