Completing the update

After the configuration node is successfully rebooted and updated, verify the update and return the system to its original state.

1. Confirm the update:
   1. Enter the lsupdate command to determine whether the software update requires a further completion step.
   2. If the lsupdate command shows that the status is system_completion_required, enter svctask applysoftware -complete in the command line interface.
   Each canister is restarted in order. The update process takes approximately 30 minutes with 5 minutes per node. During the confirmation step, the system is operational but no other updates can be started until the current update is confirmed.
2. Verify that the system is running at the correct version and that no other errors in the system must be resolved.

   To verify the new version number for the update in the management GUI, select the question mark icon in the upper right corner and select About. The version number is listed under the system identifier. Check for new alerts in the Monitoring > Events panel.

3. Verify that all the nodes are online.
   In the management GUI, use the dynamic image to view the rear of the enclosure. Ensure that both canisters in the control enclosure are online.
4. Verify that all volumes are online.
   In the management GUI, select Volumes > Volumes.
5. Verify that all managed disks (MDisks) are online.
   In the management GUI, select Pools > MDisks by Pools.
6. Restart any services, advanced functions, or scripts that were stopped before the update.