Removing and replacing the fascia: 2145-SV2 and 2145-SA2

You may need to remove and replace the fascia during some service procedures.

About this task

The following figure shows the fascia on the front of the node. The node MTM and serial number are displayed on the right end of the fascia. LED indicators to the left of the fascia also provide information about the status of the node.

Notes:

• The information on the fascia should always match the information that is printed on the rear of the node. It should also match the information that is stored on the node midplane.
• No tools are required to complete this task. Do not remove or loosen any screws on the node.

1. To remove the fascia, grasp the fascia by the left and right blue touch points.
2. Pull the fascia straight out from the node, so that the left and the right ends of the fascia release at the same time.

What to do next

To replace a fascia, hold the fascia by the blue touch points on each end and align the fascia with the front of the node so the clips on the rear of the fascia align with the four mounting posts on the node. Then, press the ends of the fascia so that the clips engage with the mounting posts and the back of the fascia is flush against the front panel of the node.