Removing the operator-information panel assembly: 2145-DH8

You can remove the operator-information panel assembly on a SAN Volume Controller 2145-DH8 node.

Before you begin

DANGER
Multiple power cords. The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords. (L003)
Multiple plugs: first set
 or
Multiple plugs: second set
 or
Multiple plugs: third set

Take precautions to avoid damage from static electricity. Wear an anti-static wrist strap and use a static-protected mat or surface.

About this task

This service action assumes:
  • The node is turned off. Ensure that the data is mirrored and synchronized, and that there are no dependent volumes. See MAP 5350: Powering off a node.
  • The power cables are disconnected.
  • The top cover is removed.

Procedure

To remove the operator-information panel assembly, complete the following steps:

  1. Read the safety information.
  2. Inside the node, disconnect the cable from the rear of the operator information panel assembly.
  3. To remove the operator-information panel, press the release latch for the light panel diagnostics panel.
  4. From the front of the node, slide the operator-information panel assembly out of the node, as shown in Figure 1.
    Figure 1. Removing the 2145-DH8 operator-information panel assembly
    Removing the 2145-DH8 operator-information panel assembly