Removing the operator-information panel assembly: 2145-SV1

You can remove the operator-information panel assembly on a SAN Volume Controller 2145-SV1 node.

Before you begin

DANGER

Multiple power cords. The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords. (L003)

Take precautions to avoid damage from static electricity. Wear an anti-static wrist strap and use a static-protected mat or surface.

This service action assumes:

The node is turned off, data is mirrored and synchronized, and there are no dependent volumes, as described in MAP 5350: Powering off a node.
The power cables are disconnected.
The top covers are removed, as described in Removing the top covers: 2145-SV1.

To remove the operator-information panel assembly, complete the following steps:

Read the safety information.
Remove the two screws from the top of the assembly, as shown in Figure 1.

Figure 1. Removing the 2145-SV1 operator-information panel assembly
Push the operator-information panel assembly from behind in the direction that is shown in Figure 1 until it protrudes from the front of the node.
From the front of the node, slide the operator-information panel assembly out of the node.
Disconnect the cables from the rear of the operator information panel assembly.