Replacing the bezel: 2145-DH8

You can replace the bezel on a SAN Volume Controller 2145-DH8 node.

Before you begin

DANGER

Multiple power cords. The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords. (L003)

Take precautions to avoid damage from static electricity. Wear an anti-static wrist strap and use a static-protected mat or surface.

This service action assumes:

The node is turned off. If you must turn off the node, ensure that hosts will not lose access to data in volumes, as described in MAP 5350: Powering off a node.
The power cables are disconnected.
The batteries are removed.

To replace the bezel, complete the following steps.

Connect the LED cable to the LED PCB on the back of the bezel assembly as shown in Figure 1.
Figure 1. Connecting the LED cable to the back of the bezel assembly
Insert the tabs on the bottom of the bezel into the slots on the underside of the chassis, and attach it with the screws, as shown in Figure 2.
Figure 2. Replacing the SAN Volume Controller 2145-DH8 bezel
If the VGA connector bolts prevent the bezel from closing up to the chassis, remove them to complete the step and then install them again.
Replace the batteries.
If you removed the node from the rack, replace the node in the rack.
If you removed any Fibre Channel or Ethernet cables, using the labels that you placed on each cable, replace them in the same ports from which they were removed.
If you removed the power cords, replace the power cords and the cable-retention brackets, as described in Replacing the cable-retention bracket.
Lift the locking levers ( 1 in Figure 3) on the slide rails and push the server 2 all the way into the rack until it clicks into place.

Figure 3. Raising the locking levers of the slide rails of the rack
Turn on the node.