The technician port is an Ethernet port on the back panel of the node
that you use to configure the node.
You can use the technician port to do these tasks:
Initialize a new system.
Service a node canister.
SAN Volume Controller 2145-SA2 and 2145-SA2 node
The node canister in the control enclosure has a 1 Gb Ethernet technician port, as shown in the
following figure. Figure 1. Technician ports PLACEHOLDER
1 Node canister technician port
2145-SV1 node
On the back of a 2145-SV1
node, the technician port is on the bottom right side of the node. Figure 2 shows the location of the technician port and other ports
that are used to service the node.
Figure 2.
2145-SV1 technician port
1 VGA port
2 Rear USB port 1
3 Rear USB port 2
4 Technician port (Ethernet)
2145-DH8 node
Starting from the left at the rear of the SAN Volume Controller 2145-DH8 node, the technician port
is the fourth Ethernet port to the right. Figure 3 shows the
rear of the SAN Volume Controller node, where
1 is the technician port.Figure 3.
2145-DH8 technician port
