SAN Volume Controller 2145-CF8 parts
You might have to replace a SAN Volume Controller 2145-CF8 field-replaceable unit (FRU).
Figure 1 shows how the different parts of the SAN Volume Controller 2145-CF8 are assembled.
- Table 1 calls out the FRUs that are referred to in service procedures.
- Table 2 calls out the FRUs that are not referred to by any SAN Volume Controller 2145-CF8 service procedure, but that might be replaced in some circumstances.
- Table 3 lists the FRUs that are related to the optional flash drive features.
- Table 4 calls out the FRU parts that are required by the long-wave small-form factor pluggable (SFP) transceiver feature.
| Assembly index | Part number | Units | Description |
|---|---|---|---|
| -1 | 44T1493 | 6 | Memory module 4 GB memory module, DDR3-1333 2RX4 LP RDIMM |
| -2 | 31P1340 | 1 | Optional: high-speed SAS adapter An assembly that includes a high-speed SAS adapter that provides connectivity for up to four flash drives, a riser card, a blanking plate, and screws. |
| -3 | 33F8354 | 1 | CMOS battery 3.0 volt battery on the system board that maintains power to back up system BIOS settings. |
| -4 | 31P1337 | 1 | 4-port Fibre Channel adapter A Fibre Channel host bus adapter (HBA) assembly that connects the SVC CF8 to the Fibre Channel fabric. It is located in PCI slot 1. The adapter assembly includes the Fibre Channel PCI Express adapter, four short-wave small form-factor pluggable (SFP) transceivers, the riser card, and the bracket. Note: If the system
is using alternative SFP
transceivers,
replace the SFP
transceivers on
the FRU part with the SFP
transceivers from
the Fibre Channel adapter that is
being replaced.
|
| -5 | 39Y7201 | 2 | Power supply unit Ac power supply, 675 Watt |
| -6 | 44E4372 | 1 | Operator-information
panel This assembly includes the information panel that contains the power-control button and diagnostics LEDs. |
| -7 | 42D0673 | 1 | Disk drive The serial-attached SCSI (SAS) 2.5 inch disk drive, which, when ordered as a replacement, might be a supported compatible drive of at least the same capacity as the one being replaced. |
| -8 | 44T2248 | 4 | Drive bay blank EMC filler assembly |
| -9 | 31P1339 | 1 | Service controller The service controller includes the front-panel display, buttons, and associated electronics. |
| -10 | 43V7071 | 1 | Disk backplane Hot-swap SAS 2.5” disk-drive backplane |
| -11 | 43V6929 | 6 | Fan assembly The fan assembly is used in each of the six fan positions. |
| -12 | 43V7072 | 1 | System board The system board is also called the planar. Note: This part is the system board
only. When replaced, you must also have alcohol wipes and thermal
grease.
|
| -13 | 44E8690 | 1 | Disk controller SAS controller for the SAS 2.5 inch disk drive that also includes the riser card. |
| -14 | 43V7067 | 1 | Disk controller / USB riser card Riser card that connects the disk controller to the system board and provides the USB port to which the service controller cable connects. |
| -15 | 46D1266 | 1 | Microprocessor 2.40 GHz Quad-core microprocessor Note: This
part is the microprocessor only. When replaced, you must also have
alcohol wipes and thermal grease.
|
| - | 31P1338 | 4 | Short-wave SFP
transceivers Small form-factor pluggable (SFP) Fibre Channel transceiver
that provides an auto-negotiating 2, 4, or 8 gigabits-per-second short-wave
optical connection on the 4-port Fibre Channel adapter.
Note: It is possible that SFP
transceivers other
than those shipped with the product are in use on the Fibre Channel
host bus adapter. It is a customer responsibility to obtain replacement
parts for such SFP
transceivers.
The FRU part number is shown as "Non standard - supplied by customer" in
the vital product data.
|
| - | 31P1206 | 1 | Service controller cable The USB cable used to connect the service controller to the system board. |
| - | 43V6922 | 1 | Disk signal cable 200 mm SAS disk signal cable |
| - | 46C4148 | 1 | Disk power cable SAS disk power cable |
| - | 31P1294 | 1 | Power cable assembly The cable assembly that connects the SAN Volume Controller and the 2145 UPS-1U. The assembly consists of two power cables bundled with a serial cable. |
| - | 49Y4817 | 1 | Cable-management arm |
| - | 46C4139 | 1 | Operator information panel cable Cable that connects the operator information panel to the system board |
| - | 41Y9292 | - | Thermal grease Grease that helps provide a thermal seal between the processor and the heat sink |
| - | 59P4739 | - | Alcohol wipe Cleaning wipe |
| Description | Part number | Quantity |
|---|---|---|
| Top cover | 43V6933 | 1 |
| Front panel moulding that surrounds the operator information panel | 49Y4818 | 1 |
| Air baffle kit (microprocessor and memory) | 43V6931 | 1 |
| Heat sink | 49Y4820 | 1 |
| Base chassis | 49Y4813 | 1 |
| Rail kit used to install the node in a rack | 49Y4816 | 1 |
| Cable management arm assembly | 49Y4817 | 1 |
| Cable retention bracket | 31P1243 | 1 |
| Front panel USB cable | 43V6920 | 1 |
| Front bezel assembly | 49Y4818 | 1 |
| DVD drive bay filler | 49Y4824 | 1 |
| 240VA safety cover | 49Y4823 | 1 |
| HDD I2C signal cable | 43V7023 | 1 |
| Description | Part number | Quantity | Feature Code |
|---|---|---|---|
| High-speed SAS adapter An assembly that includes a high-speed SAS adapter that provides connectivity for up to four flash drive. The assembly includes a riser card, a blanking plate, and two M3 screws. |
31P1340 | 1 | 4500 |
| High-speed SAS cable This cable connects the high-speed SAS adapter to the disk backplane. |
41Y3884 | 1 | |
| 146 GB Flash drive | 31P1342 | 1 to 4 | 4601 |
| Description | Part number | Quantity | Feature Code |
|---|---|---|---|
| Long-wave SFP transceiver FRU Long-wave SFP transceiver that
provides an auto-negotiating 2, 4, or 8 gigabits-per-second 10 kilometer
(km) long-wave optical connection on the 4-port Fibre Channel adapter.
Note: It
is possible that SFP transceiver other
than those shipped with the product are in use on the Fibre Channel
host bus adapter. It is a customer responsibility to obtain replacement
parts for such SFP transceiver.
The FRU part number is shown as "Non standard - supplied by customer" in
the vital product data.
|
31P1345 | 1 to 4 | 5608 |