Installing the SAN Volume Controller 2145-CF8 cable-retention brackets

Two power cords run from the uninterruptible power-supply to each of the two SAN Volume Controller 2145-CF8 power supplies. To anchor the power cords, install the two cable-retention brackets on the back of the SAN Volume Controller 2145-CF8.

About this task

The cable-retention brackets install without tools, as shown in Figure 1.

Figure 1. Cable-retention brackets

To attach the brackets, perform the following steps:

1. Loosely install the cable-retention bracket on a power cord by slipping the power cord into the notch on the rear of the bracket.
2. Align the cable-retention bracket on the power cord so that the bracket is to the left side of the cord, as shown by  2  in Figure 1.
3. Push both the bracket and the cable toward the SAN Volume Controller 2145-CF8 power supply ( 2 ), carefully aligning the power cord with the power connector on the power supply and the bracket with the power-supply handle.
4. Carefully push the bracket against the power-supply handle to force the spring clip ( 1 ) over the leading edge of the handle.
5. Push the cable and the bracket into place, as shown in Figure 1.