Removing the cable-management arm: 2145-SV1

Use this procedure to remove the SAN Volume Controller 2145-SV1 cable-management arm.

Before you begin

DANGER

Multiple power cords. The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords. (L003)

1. Remove all power from the node.

   See MAP 5350: Powering off a node for information about turning off a node.

2. Optional: Remove the front screws and slide the node out of the rack, as shown in Figure 1.
   1. Loosen and remove the front M6 screws ( 1 ).
   2. Slide the node slightly forward ( 2 ).
   3. Pull the disconnect latch forward ( 3 ).
   4. Continue sliding the node forward to access the cable-management arm ( 4 ).
   Figure 1. Sliding the node out of the rack and removing the front screws

   
3. Release the outer member, as shown in Figure 2.
   1. Press the "Push" button ( 1 ).
   2. Pull out the plug-in part of the cable-management arm to draw it out ( 2 ).
   Figure 2. Releasing the outer member of the cable-management arm

   
4. Release the outer member, as shown in Figure 3.
   1. Turn the cable-management arm to the right hand side to maintain the chassis or resume the removal ( 1 ).
   2. Press the "Push" button ( 2 ).
   3. Draw out the plug-in part of the cable-management arm ( 3 ).
   Figure 3. Removing the outer member of the cable-management arm

   
5. Release the inner member, as shown in Figure 4.
   1. Press the "Push" button ( 1 ).
   2. Draw out the plug-in part of the cable-management arm ( 2 ).
   Figure 4. Releasing the inner member of the cable-management arm