Replacing the top cover: 2145-DH8

You might be required to replace the SAN Volume Controller 2145-DH8 node top cover.

1. If you removed the node from the rack, replace the node in the rack.
2. To make sure that you can replace cables in the same ports from which they were removed, label the port position of the Fibre Channel, SAS, and Ethernet cables.
3. Position the cover on top of the SAN Volume Controller 2145-DH8.
   Important: Before you slide the cover forward, make sure that all the tabs on both the front, rear, and side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be difficult to remove the cover later.
4. Slide the cover toward the front of the node, as shown in Figure 1.
   Figure 1. Replacing the SAN Volume Controller 2145-DH8 cover

   
   •  1  Cover
   •  2  Cover release latch
5. Verify that the cover correctly engages the cover release latch, and all the inset tabs on the node.