Replacing the 240 VA safety cover: 2145-DH8

You can replace the 240 VA safety cover on a SAN Volume Controller 2145-DH8 node.

Before you begin

DANGER

Multiple power cords. The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords. (L003)

or

or

Take precautions to avoid damage from static electricity. Wear an anti-static wrist strap and use a static-protected mat or surface.

1. Line up and insert the tabs on the bottom of the safety cover into the slots on the system board, as shown in Figure 1.
   Figure 1. Replacing the SAN Volume Controller 2145-DH8 240 VA safety cover

   
2. Slide the safety cover toward the back of the SAN Volume Controller 2145-DH8 until it is secure.
3. Connect the power cables to the connector in front of the safety cover.
4. Install the screw into the safety cover.
5. Replace the PCI express rise-card assemblies.
6. Replace the air baffle.
7. Replace the top cover.
8. If you removed the node from the rack, replace the node in the rack.
9. If you removed any Fibre Channel or Ethernet cables, using the labels that you placed on each cable, replace them in the same ports from which they were removed.
10. If you removed the power cords, replace the power cords and the cable-retention brackets.
11. Lift the locking levers ( 1  in Figure 2) on the slide rails and push the server  2  all the way into the rack until it clicks into place.
    Figure 2. Raising the locking levers of the slide rails of the rack

    
12. Turn on the node.