Verifying the SAN Volume Controller 2145-DH8 installation

You must verify the installation after the installation has completed.

To verify the installation, complete the following steps.

1. Press the power-control button. Because the button is recessed, you might need a pointed device, such as a screwdriver, to press the power-control button. Verify that the green power LED is lit. If the LED is not illuminated, see MAP 5000: Start to repair the problem.
   Note: You do not need to install any software. The node boots automatically.

   The SAN Volume Controller 2145-DH8 runs an extended series of power-on self-tests. The node might appear to be idle for up to five minutes after powering on the system.

   Figure 1 shows the controls and indicators on the front panel that verify the installation. Figure 2 is a close-up view of the operator-information panel.

   Figure 1. SAN Volume Controller 2145-DH8 front panel

   
   •  1  Hard disk drive activity LED (green)
   •  2  Hard disk drive status LED (amber)
   •  3  USB port
   •  4  Video connector
   •  5  Operator-information panel
   •  6  Rack release latch
   •  7  Node status LED
   •  8  Node fault LED
   •  9  Battery status LED
   •  10  Battery fault LED
   •  11  Batteries
   •  12  Hard disk drives
   Figure 2. SAN Volume Controller 2145-DH8 operator-information panel

   
   •  1  Power-control button and power-on LED
   •  2  Ethernet icon
   •  3  System-locator button and LED (blue)
   •  4  Release latch for the light path diagnostics panel
   •  5  Ethernet activity LEDs
   •  6  Check log LED
   •  7  System-error LED (amber)
2. Verify that the node boots without error. When the battery charge is low, the battery status LED flashes.