chbootdrive

Use the chbootdrive command to synchronize a broken drive or field-replaceable unit (FRU) replacement drive. This command applies to SAN Volume Controller 2145-DH8 systems.

Syntax


>>- satask chbootdrive -- -- -sync -- --+--------------+-------><
                                        '- panel_name -'

Parameters

-sync

(Required) Specifies synchronization for:

New drives
Drives marked out of synchronization
Drives from another node

panel_name

(Optional) Specifies the panel ID of the node on which to operate.

Note: If panel_name is not supplied, this command applies to the node on which the command is running.

Description

The command synchronizes a broken or FRU replacement drive.

Remember: This command can be run only in service mode (to keep the drive boots synchronized), and can be used only on systems equivalent to SAN Volume Controller 2145-DH8. Otherwise, use the chnodebootdrive command.

An invocation example

satask chbootdrive -sync

The following output is displayed:

No feedback