Replacing the SAN Volume Controller 2145-8A4 service controller

Use the following information to replace the SAN Volume Controller 2145-8A4 service controller.

1. Gently push the service controller (shown in Figure 1) into the frame until the rear connectors are fully seated and the service controller front metal work is up to the frame.
   Figure 1. SAN Volume Controller 2145-8A4 service controller

   
2. Connect the power cable to the node and replace the cable-retention bracket. See Replacing the cable-retention bracket.
   Note: If you replaced the service controller as part of concurrent maintenance, you must rewrite the WWNN on the new service controller. If you do not, and the Fibre Channel switch zoning uses WWPNs, you cannot add the node back into the cluster until the Fibre Channel switches in the SAN are re-zoned. Also, the host systems cannot access the Fibre Channel ports on that node until the host systems are rebooted.

   You must choose either the WWNN stored on disk or the WWNN stored on the service controller to allow the node to start. If neither of these options is suitable, see the Change WWNN? option from the front panel Actions options for instructions on changing the value.