Removing and installing a SAS cable: 2145-92F

Use the following procedures to attach SAS cables to the 2145-92F enclosure during the initial installation process. You can also remove a faulty SAS cable and replace it with a new one received from FRU stock.

About this task

Be careful when you are replacing the hardware components that are located in the back of the system. Do not inadvertently disturb or remove any cables that you are not instructed to remove.

If you replace more than one cable, record which two ports, canisters, and enclosures each cable connects, so you can match the connections with the replacement cables. The system cannot operate if the SAS cabling to the expansion enclosure is incorrect. See Connecting the optional 2145-92F SAS expansion enclosures for information about SAS cabling.

When the 2145-92F expansion enclosure is installed in the rack, the expansion canisters are upside down. The input cable connects to the right port (port 1) on the expansion canister. The output cable connects to the left port (port 2) on the canister.

Procedure

Removing a SAS cable

  1. Locate the connector at the end of the SAS cable that is to be removed from the expansion enclosure.
  2. Grasp the connector by its blue tag. Pull the tag.
  3. Release the connector and slide it out of the SAS port.
  4. Repeat steps 2 and 3 on the other end of the SAS cable.

Replacing a SAS cable

  1. Ensure that the SAS connector is oriented correctly, as shown in Figure 1. The blue tab must face towards the top of the enclosure canister.
    Figure 1. Correct orientation for SAS cable connectors
    Correct orientation for SAS cable connectors
    •  1  Blue pull tab
    •  2  SAS cable
    •  3  SAS port
  2. Insert the SAS cable into the SAS port until you hear or feel a click. When the cable is successfully inserted, you cannot disconnect the cable without pulling on the blue tag.

Connecting to a SAN Volume Controller node

  1. Connect the SAS cable to the SAS port with blue tab above the connector (that is, facing towards the top of the node).

    You hear or feel a click when the cable is successfully inserted. You cannot disconnect the cable without pulling on the blue tag.

  2. Route the SAS cables through the cable management arms, as shown in Figure 2.
    Figure 2. Example of SAS cables routed through the cable management arms
    Example of SAS cables routed through the cable management arms
  3. When both ends of a SAS cable are correctly connected, the green link-LED next to the connected SAS ports are lit.

    For example, Figure 3 shows the LEDs of expansion canister 1 on a 2145-92F expansion enclosure. The SAS cable is successfully inserted in to port 1 (input); port 2 (output) does not contain a SAS cable.

    Figure 3. SAS cable correctly inserted into the SAS port
    SAS cable correctly inserted into the SAS port
Parent topic: Removing and replacing SAS cables