Removing the support rails: 2145-DH8

You can remove the support rails that hold the SAN Volume Controller 2145-DH8 node.

To remove the support rails, complete the following steps.

1. If needed, remove the node from the rack. Follow the procedure in Removing a node from a rack: 2145-DH8.
2. Remove the front end of the slide rails, as shown in Figure 1.
   1. Push up the front tab and slide out the front latch.
   2. Press the blue button  1  and lift slightly on the front of the slide rail.
   3. Remove the slide rail from the rack.

   

3. Disengage the slide rails from the rear of the rack, as shown in Figure 2.
   1. Pull the front of the slide rail forward to unlatch the rear hooks.
   2. Remove the rails from the rack.