Removing the operator-information panel cable: 2145-DH8

Edit online

You might need to remove the operator-information panel cable from a SAN Volume Controller 2145-DH8 node.

Before you begin

DANGER
Multiple power cords. The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords. (L003)
Multiple plugs: first set
 or
Multiple plugs: second set
 or
Multiple plugs: third set

Take precautions to avoid damage from static electricity. Wear an anti-static wrist strap and use a static-protected mat or surface.

About this task

This service action assumes:
  • The node is turned off. If you must turn off the node, ensure that its data is mirrored and synchronized, and that there are no dependent volumes, as described in .
  • The power cables are disconnected.
  • The node is removed.
  • The top cover is removed.

Procedure

To remove the operator-information panel cable, complete the following steps:

  1. Read the safety information.
  2. Remove the cable from the rear of the operator-information panel.
  3. Remove the cable from the connector on the right side of the node, as shown in Figure 1.
    CAUTION:
    Gently press the cable towards the fan cage; then, pull to remove the cable from the connector on the system board. Using excessive force might damage the cable or connector.
    Figure 1. Removing the 2145-DH8 operator-information panel cable
    Removing the 2145-DH8 operator-information panel cable