rescuenode
Use the rescuenode command to start automatic recovery for a specific node.
Syntax
Parameters
- panel_name
- (Optional) Identifies the node that is being serviced. Note: If
panel_nameis not supplied, it applies to the node on which the command is running. - -secureerase
- (Optional) This parameter securely erases all boot devices and returns the system to the
manufactured state. Note: This parameter is not supported on cloud systems.
- -force
- (Required) The -force parameter is required because this service
action can cause temporary or permanent loss of access to data. Use this command only when the
node reports corrupted system code. Important: Using the force parameter might result in a loss of access. Use it only under the direction of IBM® support personnel.
Description
This command starts automatic recovery for a specific node. Use this command only when the node reports corrupted code.
Note: If this node communicates to the other nodes in the system by using iSER
ports, then use the Service Assistant Tool or the satask chnodeip command to
set the IP address of the 25-Gbps Ethernet ports that are used for iSER clustering.
An invocation example
satask rescuenode -force 112233The resulting output:
No feedback